Contact Us

Simmons Racing Inc.
Custom Shop
1713 SW 51ST Street
Cape Coral,Fl 33914

Phone: 1-800-376-9907
Fax: 1-239-541-0144

E-mail: jsimmonsracing@comcast.net

“WHY SHOULD I BUY SIMMONS RACING SKATES”?
WE ARE “SIMPLY THE BEST” FROM OUR CASTINGS  TO THE CONSTRUCTION DOWN TO OUR CUSTOMER SERVICE. EACH SKATE IS HANDMADE IN THE USA WITH PRECISION AND EXCELLENCE FROM 10 LAYERS OF THE HIGHEST QUALITY CARBON FIBER, 7075  AIRCRAFT ALUMINUM MOUNTING BLOCKS, HIGHEST QUALITY EPOXY, NEOPRENE LINERS(FOR DURABILTY) AND A VARIETY OF COLOR CHOICES(ADDITIONAL COST MAY APPLY). SINCE 1991 WE HAVE BUILT THE STRONGEST AND LIGHTEST SKATES ON THE MARKET.

“WHY SHOULD I BUY A TEN DEGREE?” “ WHAT IS IT?”
THE TEN DEGREE WAS DESIGNED FROM A CONCEPT OF A COMMON PRONANTION PROBLEM THAT EXISTS WITH INLINE SKATERS (I.E. FEET FALLING TO THE INSIDE). THE MOUNTNG BLOCK IS MOUNTING AT A TEN DEGREE ANGLE TO COMBAT THIS PRONATION AND ASSIST YOU TO GET ON YOUR EDGES.

“HOW DO I KNOW WHAT SERIES OF SIMMONS SKATES (WIDTH SIZING) I SHOULD BUY?”
SINCE WE OFFER 4 DIFFERENT VERSIONS OF FIT SIZES, NARROW, WIDE, K SERIES AND S SERIES. WE SUGGEST YOU SEND US A FOOT TRACING AND CONTACT US, THEN WE CAN BETTER EXPLAIN WHAT MIGHT BE THE BEST FIT FOR YOU .

“CAN I AND HOW  DO I HEAT MOLD MY SIMMONS RACING SKATE?”
YES, OUR SKATES CAN BE HEAT MOLDED IN TWO DIFFERENT WAYS.
OVEN MOLDING: PRE-HEAT OVEN TO 210 DEGREES. ONCE DESIRED TEMPERATURE IS REACHED, TURN OVEN OFF PLACE BOOT IN FOR 10-15 MINUTES. CHECK BOOT FOR SOFTNESS,(MAKE SURE TO CHECK BOOT SO IT DOESN'T MELT) REMOVE AND PLACE ON FOOT. WE RECOMMEND DOING ONE BOOT AT A TIME.

HEAT GUN MOLDING: WHILE USING CAUTION, HEAT THE AREA OF THE BOOT THAT NEEDS MOLDING. DO NOT OVERHEAT OR PLACE HEAT GUN TOO CLOSE. APPROXIMATELY 10 OR SO INCHES AWAY WILL SUFFICE.